Suction power for the floor washer ranges from 10 AW to 18AW (Air Watts) depending on how dirty the floor is.

There is no need to vacuum an area first because the Floor One can vacuum and wash the floor simultaneously.

The Floor One can be used on non-carpeted floor such as vinyl, tile, and sealed wood floors.

The Floor one can‘t be used without water for dry vacuuming. It will cause damage to the brush roller. Ideally you should use the Floor One with solution and water to automatically adjust solution and clean water flow to ensure an ideal cleaning result.

It is not recommended to use a third party cleaning solution because the floor washer is designed to be used with the Tineco Cleaning Solution to optimize the amount of bubbles that are produced with cleaning solutions. Third party solutions can cause an over abundance of bubbles when cleaning that could fill up the Dirty Water Tank within minutes of use.

The floor washer produces up to 78dBA of sound.

To start the Floor One's self-cleaning mode, please follow the following steps: Always keep the floor washer plugged in. Place the floor washer on the charging dock. Empty the Dirty Water Tank. The Clean Water Tank should be at least 1/3 full of water. Press self-cleaning button at the top of the handle to evoke self cleaning, press it again to choose either quick self-cleaning or Super self cleaning, and 3 seconds later, the chosen brush roll self-cleaning mode will start. Afterwards, the floor washer will automatically shut off once finished. The entire self-cleaning process takes about 120 seconds (quick mode) / 360 seconds (super mode).